FUTABA T12K

155
<Model Menu (Airplane/Glider/Multirotor Functions)>
●Selectthefunctionname
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
<Push Dial>
RETURN
TRIM MIX
[Correspondingmodeltype]:Glider,2aileronsormore
This function adjusts the trim offset rates of the
ailerons, elevators, rudder and aps (camber aps,
brake aps) according to the ight status.
As an example this function can be set up for
launching, with speed aps and ailerons drooped,
and a slight amount of up elevator. It can also be
used for high speed ying, with both ailerons and
speed flaps reflexed slightly, and a bit of down
elevator.
To prevent sudden trim changes when switching
ight conditions, a delay can be set to provide a
●Select[TRIMMIX]attheModelmenu
and access the setup screen shown
below by pushing the RTN button.
*The display screen is an example. The actual
screen depends on the model type.
smooth transition between the two conditions. It
is also possible to program a cut switch, which
will turn off the delay.
Furthermore, you can set the auto switch, which
will link the trim mix to a stick, switch, or dial.
Additionally, the speed of the aileron, elevator,
rudder, and ap servos can be adjusted.
(Currently selected condition name)
●Conditiondelay
setting
●Ailerons,aps,elevators
and rudder servo
speed setting
●Autoswitchselection
●Ailerons,flaps,elevators
and rudder offset rate
●Switch
selection
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
●Toinputdatamode
●Dataisentered