FUTABA T12K

156
<Model Menu (Airplane/Glider/Multirotor Functions)>
Setting method
●Activate the function
 Movethecursortothe[ACT]itemandpush
the RTN button to switch to the data input
mode.SelecttheACTmodebyscrollingthe
Pushdial.
*The display blinks.
 PushtheRTNbuttontoactivatethefunction
andreturntothecursormode.(ONis
displayed.)
When setting a switch, move the cursor to
the switch item and push the RTN button
toaccesstheselectionscreen.Selectthe
switchandsetitsONdirection.(AlwaysON
at"--"setting)
*For a description of the switch selection method, see the
description at the back of this manual.
●Trim offset rate adjustment
Move the cursor to the aileron, flap or
elevator rate item and push the RTN button
toswitchtothedatainputmode.Adjustthe
rateindependentlybyscrollingthePushdial.
 Initialvalue:0%
 Adjustmentrange:-250~+250%
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
 PushtheRTNbuttontoendtheadjustment
and return to the cursor mode.
●Condition delay setting
 Movethecursortothe[COND.DELAY]item
and push the RTN button to switch to the
datainputmode.Adjusttheconditiondelay
byscrollingthePushdial.
 Initialvalue:0
 Adjustmentrange:0~27
*When the RTN button is pushed for one second, the servo
operation position is reset to the initial value.)
 PushtheRTNbuttontoendtheadjustment
and return to the cursor mode.
When setting a cut switch, move the cursor
tothe[CUT-SW]itemandpushtheRTN
buttontoaccesstheselectionscreen.Select
theswitchandsetitsONdirection.(Always
ONat"--"setting)
*For a description of the switch selection method, see the
description at the back of this manual.
●Servo speed setting
Move the cursor to the aileron, flap or
elevator speed item and push the RTN button
to switch to the data input mode.
 AdjusttheratebyscrollingthePushdial.
 Initialvalue:0
 Adjustmentrange:0~27(maximumdelay)
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
 PushtheRTNbuttontoactivatethefunction
and return to the cursor mode.
●Auto switch selection
When selecting an auto switch, move the
cursortothe[AUTO-SW]itemandpushthe
RTN button to access the selection screen.
SelecttheswitchandsetitsONdirection.
(AlwaysONat"--"setting)
*For a description of the switch selection method, see the
description at the back of this manual.
AIL 3
(Chip Aileron)
AIL 4
(Chip Aileron)
AIL1
(Main Aileron)
AIL 2
(Main Aileron)
FLP 2
(Camber Flap)
FLP 1
(Camber Flap)
ELEVATOR
ELEVATOR 2
V-TAIL
ELEVATOR
ELEVATOR 2
AILEVATOR
FLP 3
(Brake Flap)
FLP 4
(Brake Flap)