Your T12K includes the following components:
(Specications and ratings are subject to change without notice.)
• T12K Transmitter
• R3008SB Receiver
• HT5F1800B NiMH Battery & Charger
*The set contents depend on the type of set.
Transmitter T12K
(2-stick, 14-channel, T-FHSS Air-2.4G system)
Frequency band
: 2.4GHz band
RF power output
:
100mW EIRP
System: T-FHSS Air, S-FHSS, switchable
Power supply: 6.0V HT5F1800B NiMH battery
Receiver R3008SB
(T-FHSS Air-2.4G system, dual antenna diversity, S.BUS system)
Frequency band
: 2.4GHz band
RF power output
:
25mW EIRP
Power requirement: 4.8V~7.4V battery or regulated output from ESC, etc. (*1)
Size: 0.98 x 1.86 x 0.56 in. (24.9 x 47.3 x 14.3 mm)
Weight: 0.36 oz. (10.1g)
(*1) When using ESCs, make sure that the regulated output capacity meets your usage application.
Note: The battery in the T12K transmitter is not connected to the battery
connector at initial. Please connect the battery connector before use.
System Compatibility
Contents and Technical Specications
The
12K
is a
2.4GHz T-FHSS Air system
. The transmitter can also be switched to
S-FHSS
. (However, the telemetry
system cannot be used with S-FHSS.) The usable receivers are shown below.
NOTE：
*The Futaba
T-FHSS Air
system
cannot
be used with Futaba
S-FHSS/FASST/FASSTest
systems.
Use it with a
T-FHSS Air
system transmitter and receiver. The
T12K
is a
T-FHSS Air system
,
but can also be used with an
S-FHSS
receiver by switching to
S-FHSS
. However, in this case the
telemetry system cannot be used.
*The
T-FHSS Air system
and
T-FHSS
surface system are different. The
T12K
cannot be used with
the
R304SB, R304SB-E
or
T-FHSS
surface system receivers.
Communications System
Usable Receivers (2017,11)
T-FHSS Air
R3006SB, R3008SB,
R3001SB
S-FHSS
R2001SB, R2008SB,
R2006GS, R2106GF
To Next Page
Loading...
