FUTABA T12K

190
<Appendix>
The various functions used in the T12K can
be activated by a switch. For the purposes of this
manual, a stick position, VR position, etc. shall
be commonly referred to as a switch in all cases.
(Switchselectionscreenexample)
When the switch is selected
Once the switch is selected, the ON/OFF
setting is also activated.
*The ON/OFF setting state of each position is displayed.
1.WhenyouwanttochangetheON/OFF
setting,usethePushdialtomovethe
cursorandpushtheRTNbuttontoswitch
tothedatainputmode.SwitchtheON/
OffdisplaybyscrollingthePushdial.
*ON/OFF display blinks.
2.WhentheRTNbuttonispushed,theON/
OFFsettingischanged.(PushtheS1
buttontostopthechange.)
3.Toreturntothepreceedingscreen,move
thecursortothe[ON/OFF]atthetopof
thescreenandpushtheRTNbutton.
When stick, trim lever, or knob selected
When a stick, trim lever, or knob is used as a
switch, two operation modes can be selected:
1.Whenyouwanttochangethemode,
movethecursorto[MODE]itemandpush
theRTNbuttontoswitchtothedatainput
mode.Switchthedisplaytothemodeyou
wanttochangebyscrollingthePushdial
andthenmakethechangebypushing
theRTNbutton.
●
Mode:[LIN]/[SYM]
* Set the ON/Off point by the method described on the next page.
Switch selection
1.UsethePushdialtomovethecursor
(highlights)totheswitchyouwantto
selectandpushtheRTNbutton.
*The switch blinks.
2.Toreturntothepreceedingscreen,move
thecursortothe[H/WSELECT]atthetop
ofthescreenandpushtheRTNbutton.
 Or,movethecursortothe[ON/OFF]and
calltheON/OFFpositionsettingscreenby
pushingtheRTNbutton.
Alternate mode setting
 ●ALTERNATE mode:[OFF]/[ON]
1.Movethecursortothe[ALTERNATE]item
andpushtheRTNbuttontoswitchtothe
datainputmode.
2.Changetothemodeyouwanttosetby
scrollingthePushdial.
*The mode display blinks.
3.PushtheRTNbutton.(PushtheS1buttonto
stopthechange.)
4.Toreturntothepreceedingscreen,move
thecursortothe[ON/OFF]atthetopofthe
screenandpushtheRTNbutton.
Switch Setting Method
Switch selection
When a switch is selected at a mixing function, etc., the selection screen shown below appears.
Whenever the manual indicates that something is
operated via a switch, it is possible for the user to
activate this setting via a stick, stick position, etc.