Up/Down timer (ST1, ST2)
• Timer is displayed here.
Push the RTN button at the [xx]:[xx.xx]
item to start/stop the timer.
• Use the cursor to highlight this, then
push the RTN button at the ST1 or ST2
item to call the timer setup screen.
*See the description at the back of this manual.
Digital trim (T1 to T4)
• Trim position is displayed here.
• You can select the display unit
on the home screen on the
T1-T4 setting screen within the
linkage menu.
Model Name
• The model name that
is currently used is
displayed here.
• Use the cursor to
highlight this, then
push the RTN button
to call the model
select set-up screen.
User name
System timer
• This shows the accumulated time since
the latest reset. (Hour):(Minute)
• Use the cursor to highlight this, then
push the RTN button for one second
to reset the system timer.
Use the Push dial to select the following display area to call each setting screen, and push the RTN
button. The setting screen appears.
RF indicator
Battery Indicator
• When the battery voltage
reaches 5.6V(Change in
Warning Menu), the alarm
will beep. Land your aircraft
immediately.
System mode
• System(T-FHSS Air or S-FHSS)
mode is displayed here.
• Use the cursor to highlight this,
then push the RTN button to call
the frequency set-up screen.
2
nd
Home screen
• Push the RTN button at
the clock icon to call the
2
nd
home screen (large
size timer).
Model timer
• This shows the accumulated time
since the latest reset. (each model)
(Hour):(Minute)
• Use the cursor to highlight this, then
push the RTN button for one second
to reset the model timer.
Key lock
• Push the S1 button or push the HOME/
EXIT button for one second to lock/
unlock the key operation.
In the key lock mode the key icon is
displayed here.
Model type
micro SD card indicator
Condition name (Heli/Glider)
• In the normal condition, move the
cursor to the condition name and
push the RTN button. The condition
name is changed and blinks.
It is possible to operate the digital
trim in all conditions.
VPP condition # (Air)
• When VPP function is assigned to a
channel, the current VPP condition
# is displayed here.
Home Screen
To Next Page
Loading...
