FUTABA T12K

145
<Model Menu (Airplane/Glider/Multirotor Functions)>
●Selectthefunctionname
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
<Push Dial>
RETURN
RUDDER 2
RUDDER
RUDDER
V-TAIL
RUDDER 2
Winglet
RUDDER 1
Winglet
at Flying wing
at Flying wing
( )
( )
AIL 3
AIL 3
(Chip Aileron)
(Chip Aileron)
AIL1
(Main Aileron)
AIL 2
(Main Aileron)
AIL to RUD
[Correspondingmodeltype]:Airplane/glider,general
Use this mix when you want to mix the rudders
with aileron operation. This allows the aircraft to
bank at a steep angle.
●MixingduringflightcanbeturnedON/OFFbya
switch.(AlwaysONat[--]setting)
●Themixingratecanbeadjusted.
●Select[AILtoRUD]attheModel
menu and access the setup
screen shown below by pushing
the RTN button.
*The display screen is an example.
The actual screen depends on the
model type.
(Glider: Currently selected condition name)
Setting method
●Activate the function
 Movethecursortothe[ACT]itemandpush
the RTN button to switch to the data input
mode.SelecttheACTmodebyscrollingthe
Pushdial.
*The display blinks.
 PushtheRTNbuttontoactivatethefunction
andreturntothecursormode.(ONis
displayed.)
When selecting a switch, move the cursor to
the[SW]itemandpushtheRTNbuttontocall
theselectionscreen.Selecttheswitchand
setitsONdirection.(AlwaysONat"--"setting)
*For a description of the switch selection method, see the
description at the back of this manual.
●Mixing rate adjustment
Move the cursor to the left or right item
and push the RTN button to switch to the
datainputmode.Adjustthemixingrate
independentlybyscrollingthePushdial.
 Initialvalue:0%
 Adjustmentrange:-100~+100%
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
 PushtheRTNbuttontoendtheadjustment
and return to the cursor mode.
●Fine tuning
Operation Mode
When the ne tune control is set, it is
displayed.
Mode : LIN. / ATL+ / ATL- / SYM.
Actual rate
It can be set by each conditions.
The ne tune control
hardware
The ne tune rate
Range ： -100 ～ +100%
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Toinputdatamode
●Dataisentered