● Lock release
Every lock function's push [ 1 second
or more ] of S1 button will release the
lock.
● Lock release
Every lock function's push [ 1 second
or more ] of HOME/EXIT button will
release the lock.
● Manual lock
If S1 button is pushed 1 second or
more from a HOME screen, a Push
Dial locks manually.
● Manual lock
If HOME/EXIT button is pushed 1
second or more from a HOME screen,
a Push Dial locks manually.
● Display of a lock
If locked, there will be sound and the
icon of a key will come out.
Auto lock method
1. Open the Auto lock screen in the system
menu.
2. Adjust the activation timer for the Auto
Lock function. The timer will begin counting
immediately when the HOME screen is not
used. The timer is adjustable in one second
increments, up to 30 seconds. If the timer
value is OFF, this function is not applicable.
3.The Start Lock setting will, if enabled,
automatically lock the T12K when the
transmitter is powered up. To allow access to
the transmitter's functions, push and hold the
S1 key for one second.
*If neither the Lock Timer or Start Lock functions are active
(OFF), then the key lock remains even if the power is turned off.
*If the Lock Timer is enabled and the Start Lock is off, the key
lock status is canceled each time the T12K is turned on.
The Auto Lock function makes it possible to lock
the transmitter to prevent any unwanted input from
your hands while ying.
The auto lock function can be set in two ways.
LOCK TIMER
Auto Lock functions automatically when there is
no operation from the HOME screen display for a
chosen number of seconds.
START LOCK
Auto Lock functions automatically when the
model changes or power is turned on.
*To temporarily allow access to the T12K programming push
and hold the S1 or HOME/EXIT bitton for one second.
Please note, the Auto Lock function timer will resume
immediately once again.
AUTO LOCK
The automatic lock function of two kinds of Push Dial
Danger
It is recommended to Lock the Push
Dial during flight to prevent any
accidental pushes which could change
settings and cause an accident.
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To input data mode
● Data is entered
To Next Page
Loading...
