FUTABA T12K

127
<Model Menu (Common Functions)>
●Selectthefunctionname
andreturntotheModel
menubypushingthe RTN
buttonor pushingthe
HOME/EXITbutton.
<Push Dial>
RETURN
CONDITION
Flightcondition'sswitchassignment,copy,prioritychangeand
conditiondelaycanbeset[exceptairplanetype].
This function, in the Model menu, can be used
to switch the settings of up to 5 ight conditions.
Please note this is not applicable to airplane type
selections.
Note: To prevent accidental activation of any
unused ight conditions during ight, set the
switch setting of those unused conditions to
null [--].
●AConditionDelayfunctioncanbeset
topreventunnecessaryfuselagemotion
whichmaybegeneratedwhenthereare
suddenchangesintheservopositionsand
whentherearevariationsintheoperating
timebetweenchannelsduringcondition
switching.Thedelaycanbesetforeach
channeltoensuremaximumperformance
fromyouraircraft.
Whensettingthedelayfunctionforaspecic
ightcondition,therelatedfunctionchanges
afteradelaycorrespondingtotheset
amount.
●Ifmultipleconditionswereset,their
operationalprioritymaybecustomizedas
desired.
(Currently selected condition name)
●Select[CONDITION]attheModelmenuand
accessthesetupscreenshownbelowbypushing
theRTNbutton.
pushtheRTNbutton.
 Selectthecopydestinationconditionby
scrollingthePushdial.Then,pushtheRTN
button.
*The current condition cannot be selected for the copy
destination condition.
3.Movethecursortothe[COPY]itemandpush
theRTNbutton.Aconfirmationmessage
appears.
*The display blinks.
4.PushtheRTNbuttonforonesecondandthe
copyingiscompleted.(PushtheS1buttonto
stopcopying.)
Priority change
1.Movethecursortothepriorityup-arrowor
down-arrowyouwanttochangeandpush
theRTNbutton.
 Thepriorityofthecorrespondingconditionis
changed.(Thelastconditionbecomesthe
highestpriority.)
*The Normal condition cannot be changed or moved. Its
priority is always the lowest.
Condition switch selection/deletion
1.Movethecursortotheswitchitemofthe
conditionyouwanttoselect/deleteand
accesstheswitchsetupscreenbypushing
theRTNbuttonandselecttheswitchandON
direction.
*For a detailed description of the setting method, see [Switch
Setting Method] at the back of this manual.
Condition copy
(Setup screen page 3)
1.Movethecursortothe[SOURCE]itemand
pushtheRTNbuttontoswitchtothedata
inputmode.
 Selectthecopysourceconditionbyscrolling
thePushdial.Then,pushtheRTNbutton.
2.Movethecursortothe[DESTIN.]itemand
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
(Condition name) (Condition switch)