FUTABA T12K

133
<Model Menu (Common Functions)>
●Selectthefunctionname
andreturntotheModel
menubypushingthe RTN
buttonor pushingthe
HOME/EXITbutton.
<Push Dial>
RETURN
FUEL MIX
Dedicatedmixingusedtoadjustthefuelmixtureofapplicable
engines.[Airplane/helicopter]
This function is used to refine in-flight needle
adjustments of engines that offer mixture control
carburetors.
Note: Initial settings do not assign fuel mix to
any channel. Prior to using the Fuel Mix
settings, select an unused channel on your
receiver and assign it accordingly for the
mixture control. Additionally, please make
sure that your [Control] and [Trim] are set to
null [--].
●Select[FUELMIX]attheModelmenuand
accessthesetupscreenshownbelowby
pushingtheRTNbutton.
●Accelerationsetting
●Needlehightrim
selection
[Airplanetype]
[Helicoptertype]
●Enginecutsetting
●Mixingcurvecopyfunction
 MovetheCOPYitemandpushtheRTN
buttontoswitchtothedatainputmode.
Selectthecopydestinationconditionby
scrollingthePushdialandpushtheRTN
button.Select[YES]andpushtheRTN
button.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
●Toinputdatamode
●Dataisentered