FUTABA T12K - Model Menu (Helicopter Functions); Helicopter Model Menu Overview

170
<Functions of Model Menu (Helicopter Functions)>
●Selectthefunctionname
andreturntotheModel
menubypushingthe RTN
buttonor pushingthe
HOME/EXITbutton.
<Push Dial>
RETURN
MODEL MENU (HELICOPTER)
This section contains information on helicopter-
only commands. For instructions on Airplanes and
Gliders, refer to the sections pertaining to those
aircraft.
Use the Model Type function in the Linkage
Menu to select the swash type matched to the
respective aircraft.
Also, activate/deactivate flight conditions
according to your model. To do so, access the
Condition Select screen prior to adjusting the
model's parameters. (Up to ve conditions can be
used)
The Dual Rate function and other functions
common to all model types have already been
described elsewhere in this manual. Please refer to
these respective sections for information on how to
do so.
Model Menu functions (helicopter) list
PIT CURVE: Adjusts pitch settings in different ight conditions.
THR CURVE: Throttle curve and hovering trim adjustment in different ight conditions.
THR HOLD: Moves the throttle to idle during auto-rotation.
SWASH MIX: Compensates control response in different ight conditions.
THROTTLE MIX: Compensates for power loss when cyclic is applied.
PIT to NEEDLE: Adjusts pitch response in different ight conditions.
PIT to RUD: Compensates torque changes from pitch angle inputs.
GYRO: Used to switch gyro sensitivity.
GOVERNOR: Used to switch RPM of the helicopter’s head.
●Selectthefunctionyou
wanttosetandaccess
thesetupscreenby
pushingtheRTNbutton.
●Callthemodelmenushownbelowbylong
pushingtheMDLbuttonatthehomescreen,
etc.
Scrolling
●Movingcursor
●Tonextpage
●Callingsetupscreen