FUTABA T12K

142
<Model Menu (Airplane/Glider/Multirotor Functions)>
●Selectthefunctionname
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
<Push Dial>
RETURN
FLP 2
(Camber Flap)
FLP 1
(Camber Flap)
FLP 3
(Brake Flap)
FLP 4
(Brake Flap)
FLAP SET.
[Correspondingmodeltype]:Airplane/glider,2apsormore
The up/down travel of each ap (camber aps:
FLP1/2, brake flaps: FLP3/4) can be adjusted
independently for each servo according to the
wing type.
●Theoperationreferencepointofeachapcanbe
offset
The camber flaps of a 4-flap model can
be mixed with the brake flaps. (BRKFLP to
CMBFLP)
●AnON/OFFswitchcanbeset.
*The display screen is an example. The actual
screen depends on the model type.
Setting method
●Flap up/down adjustment
 Movethecursortotheflap(FLP)1~4Upor
Down item according to the wing type and
push the RTN button to switch to the data
inputmode.Adjustthetravelindependently
byscrollingthePushdial.
 Initialvalue:+100%
 Adjustmentrange:-120~+120%
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
 PushtheRTNbuttontoendtheadjustment
and return to the cursor mode.
●Reference point adjustment
 Movethecursortothe[OFFSET]itemand
push the RTN button to switch to the data
inputmode.Adjusttheoperationreference
pointofeachapbyscrollingthePushdial.
 Initialvalue:0%
 Adjustmentrange:-100~+100%
*When the RTN button is pushed for one second, the
reference point is reset to the initial value.)
 PushtheRTNbuttontoendtheadjustment
and return to the cursor mode.
●Activate the Brake FLP to Camber FLP mixing
 Movethecursortothe[ACT]itemandpush
the RTN button to switch to the data input
mode.SelecttheACTmodebyscrollingthe
Pushdial.
*The display blinks.
 PushtheRTNbuttontoactivatethefunction
andreturntothecursormode.(ONis
displayed.)
To select a switch, move the cursor to the
[SW]itemandpushtheRTNbuttontocallthe
selectionscreen.Selecttheswitchandsetits
ONdirection.(AlwaysONat"--"setting)
*For a description of the switch selection method, see the
description at the back of this manual.
●Select[FLAPSET.]attheModelmenuandaccessthesetup
screen shown below by pushing the RTN button.
(Glider: Currently selected condition name)
●Operationreference
point offset
●Up/Down
adjustment
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
●Toinputdatamode
●Dataisentered