FUTABA T12K

139
<Model Menu (Airplane/Glider/Multirotor Functions)>
●Selectthefunctionname
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
<Push Dial>
RETURN
THR-DELAY function is used to slow the
response of the throttle stick to simulate the slow
response of a turbine engine, etc.
*THR DELAY serves the same function as servo speed THR.
Use one or the other, not both. If both are used, the servo
delay could be greater than intended.
●Select[THRDELAY]attheModelmenu
and access the setup screen shown
below by pushing the RTN button.
THR DELAY
[Correspondingmodeltype]:Airplane,general
Setting method
●Operation speed (delay) setting
1.Movethecursortothe[DELAY]itemand
push the RTN button to switch to the data
input mode.
 AdjustthedelayratebyscrollingthePush
dial.
 Initialvalue:0
 Adjustmentrange:0~27(maximumdelay)
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
 PushtheRTNbuttontoactivatethefunction
and return to the cursor mode.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Toinputdatamode
●Dataisentered