FUTABA T12K

75
<Functions of Linkage Menu>
●Selectthefunctionname
andreturntotheLinkage
menubypushingthe RTN
buttonor pushingthe
HOME/EXITbutton.
<Push Dial>
RETURN
SERVO MONITOR
ServoTest&GraphDisplay/Displaysservopositions.
This is used for testing servo movement.
“Moving Test” (repetition mode) and “Neutral
Test” (xed position mode) are available.
The “Neutral Test” is good for finding the
neutral position of a servo horn.
In order to prevent any potential difficulties,
the servo test function will be inoperable, or
inaccessible, under certain conditions. Specically,
the Servo Test function is not operational if the
throttle cut is ON in either airplane or helicopter
modes; or if the throttle hold is ON in helicopter
mode.
●Select[SERVO]intheLinkagemenuandaccess
thesetupscreenshownbelowbypushingtheRTN
button.
●A[U.MENU/MON.]buttonispushedoncefroma
homescreen.
Servo test operation
1.Movethecursortothe[OFF]itemandpush
theRTNbuttontoswitchtothedatainput
mode.
 SelectthetestmodebyscrollingthePush
dialandpushtheRTNbutton.Thedisplay
blinks.PushtheRTNbuttontochangethe
mode.(Toterminatemodechange,push
theS1button.)
 [MOVING]:Modewhichrepeatsoperationof
eachservo
 [NEUTRAL]:Modewhichlockseachservoin
theneutralposition
2.Movethecursortothe[MOVING]or
[NEUTRAL]itemandpushtheRTNbuttonto
switchtothedatainputmode.
 Selectthe[OFF]byscrollingthePushdialand
pushtheRTNbutton.Testingisstopped.
Scrolling
●Movingcursor
●Selectingmode
●Toinputdatamode
●Dataisentered