FUTABA T12K - Model Select

76
<Functions of Linkage Menu>
●Selectthefunctionname
andreturntotheLinkage
menubypushingthe RTN
buttonor pushingthe
HOME/EXITbutton.
<Push Dial>
RETURN
MODEL SELECT
TheModelSelectionfunctionperformsmodeladdition,selection,
deletion,copy,andmodelnamesetting.
This function is used to load the settings of the
desired model into the T12K’s memory.
The settings may be selected from either the
transmitter’s internal memory or a micro SD card.
Remember that up to 30 model memories are available
in the transmitter.
The name of the model stored in the transmitter
and the micro SD card may be changed. This can be
very useful to tell different models settings apart. Each
model name can be as long as 10 characters, and the
model name always appears in the display screen.
The Copy function is used to copy parameters,
settings, etc. from one model data into a second
memory. It may be used for getting a head-start on
setting up models with almost the same settings (only
differences need to be modied, instead of entering the
complete model from scratch). Also, this function may
be used to make a backup copy of a model setup before
any changes are made.
Model selection
*Model data saved on the transmitter memory other than the
model currently used can be selected.
1.Movethecursortothesavedestination
display("TX"or"CARD")andpushtheRTN
buttontoswitchtothedatainputmode.
 Selectthesavedestinationbyscrollingthe
PushdialandpushtheRTNbutton.
 [TX]:Transmittermemory
 [CARD]:microSDcard
2.Aftermovingthecursortothedesiredmodel
inthemodellist,pushtheRTNbutton.
3.Moveto[SELECT].
4.PushtheRTNbutton.Aconrmationmessage
isdisplayed.PushtheRTNbuttonforone
secondandselectioniscomplete.
*Transmission stops and then starts in the new model.
Model addition
*A new model can be added to the transmitter memory. It
cannot be added to the micro SD card.
1.Movethecursorto[NEW].
2.PushtheRTNbutton.Aconrmationmessage
appears.PushtheRTNbuttonforone
second.
*The model type setup screen and frequency setup screen are
automatically displayed. Conrm or change the model type
and SYSTEM mode.
*Transmission stops and then starts in the new model.
*The added model appears in the model list of the model
select setup screen.
*Link is required when a new model is
made from a model selection.
●Select[MODELSELECT]intheLinkagemenuand
accessthesetupscreenshownbelowbypushing
theRTNbutton.
*The display screen is an example. The
screen depends on the model type.
(Modellist)
Currentmodel
Scrolling
●Movingcursor
●Selectingmode
●Dataisentered