FUTABA T12K

175
<Functions of Model Menu (Helicopter Functions)>
Normal Curve Idle-up 1 Curve Idle-up 2 Curve
●Throttle Curve (Example)
The curves shown below are created by inputting
the data of the 5 points for each condition, 0%
(low side), 25%, 50% (center), 75%, 100% (high)
side. When creating a curve, enter the parameters
specied per the model (or the reference value).
Curve setting examples
Throttle Hover trim
Setting method
●SetthefunctiontoACT([ON]).(initialsetting)
●Selecttheadjustmentknob.
 Selectionexample:RD(initialsetting)
●Thetrimoperationmode(Mode:CTRM/
NORM)canbeselected.
 CTRM mode:Maximumrateofchange
nearcenterbycentertrimoperation
(recommended)
 NORM mode: Normaltrim(horizontal
movementtrim)operation.
●Thetrimratecanbeadjustedandthe
operationdirectioncanbeset.
●Trimadjustmentrange(Range)setting
 Withsmallervalues,thetrimisonlyactive
nearthecenter.
[Throttlehovertrimsetting]