FUTABA T12K

176
<Functions of Model Menu (Helicopter Functions)>
Throttle limiter function
Setting method
*Set at the 3rd page of the throttle curve screen.
•Activate the function.
1.SelectACTandpushtheRTNbutton.
2.SwitchthedisplaytoACTbyscrollingthe
Pushdial.
*Thedisplayblinks.
 INH:Inhibit
 ACT:Activate
3.EntertheselectionbypushingtheRTN
button.
•ON/OFF switch setting
1.SelectSWandpushtheRTNbutton.
2.TheH/WSETscreenisdisplayed.Selectthe
hardwareandpushtheRTNbutton.
This function limits the high range of the throttle
movement by any slider or trimmer.
*Control which adjusts the limit point during ight can be set.
•High side operating range setting
1.SelectHIGHandpushtheRTNbutton.
2.Adjustthehighsideoperatingrangeby
scrollingthePushdial.
*A gauge is displayed at the left side of the graph.
3.PushtheRTNbuttontoswitchtothecursor
mode.
•Low side operating range setting
1.SelectLOWandpushtheRTNbutton.
2.Adjustthelowsideoperatingrangeby
scrollingthePushdial.
*A gauge is displayed at the left side of the graph.
3.PushtheRTNbuttontoswitchtothecursor
mode.
•Limiter operating range adjustment control
setting
1.SelectCTRLandpushtheRTNbutton.
2.TheH/WSETscreenisdisplayed.Selectthe
hardwareandpushtheRTNbutton.
*The throttle limiter operating position is indicated by a
dotted line on the graph.
*When limiter operating range adjustment control is NULL,
the throttle limiter function is not performed.
•Changing the control center position
1.SelectCENTERandpushtheRTNbuttonfor1
second.CENTERchangesfromINHto“rate
display”.
2.WhentheCENTERrateischanged,the
neutralpositionofthehardwaresetatCTRL
canbeadjusted.
*When CENTER is INH, the neutral position becomes the
LOW intermediate value.
*When CENTER is changed from INH to “rate display”, the
CENTER rate is set to the LOW intermediate value.
*The CENTER rate can be set between HIGH and LOW.
[Throttlelimitersetting]
When "CTRL" is set as a "RS" side slider.
The state of full high of a throttle stick.
“RS”Position
Throttle
Position
Full
RestrictionRestriction
Restriction
Slow
Full
Slow
Full
Slow
In "INH", the halfway
point of "HIGH" and
"LOW".
HIGH
LOW
CENTER