FUTABA T12K

49
<Receiver and Servo Installation>
MODEL BASIC SETTING PROCEDURE
1. Model addition and selection
Initially, the T12K assigns the first model to
model-01 in the transmitter. The Model Select
function of the Linkage Menu is used to add
models and to select amongst models which are
already set.
The T12K is capable of storing data for up to 30
models in its internal memory. Additional model
data can also be saved to an optional micro SD
card.
The currently selected model name is displayed
in the center of the home screen. Before ying and
before changing any settings, always confirm the
model name.
When a new model is added, the Model type
select screen and System mode setup screen
automatically appear. Please be aware that the
transmitter will stop transmitting temporarily when
you change the model.
When a new model is added, you will need to re-
link the receiver.
2. Model type selection
Select the model type matched to the aircraft
with the Model Type select function of the Linkage
Menu. For an airplane, select the model type from
among the 2 types: airplane and glider. And then
select the wing type and the tail type matched to
the aircraft.
Airplane/glider basic setting procedure
3. Fuselage linkage
Connect the ailerons, elevators, throttle, rudder,
etc. in accordance with the model's instruction
manual. For a description of the connection
method, see the Receiver and Servos Connection.
Note that even for the same "airplane
model", when the wing type and tail type
are different, the channel assignment may
be different. (The channel assigned to each
function can be checked at the Function
menu of the Linkage Menu.)
● Ifthedirectionoftheservoisincorrect,adjust
thedirectionwiththeReversefunctionofthe
LinkageMenu.
● Adjusttheneutralpositionandcontrol
surfaceanglewiththelinkage,andfine
tunethemwiththeSub-TrimandEndPoint
functions(angleadjustment).Toprotectthe
linkage,alimitpositioncanalsobesetwith
theEndPointfunction.TheEndPointfunction
canadjusttheamountofup/downandleft/
rightmovementandlimitofeachchannel.