FUTABA T12K

78
<Functions of Linkage Menu>
●Selectthefunctionname
andreturntotheLinkage
menubypushingthe RTN
buttonor pushingthe
HOME/EXITbutton.
<Push Dial>
RETURN
MODEL TYPE
Thisfunctionselectsthemodeltypefromamongmultirotor,airplane,
helicopter,andglider.
(The display screen is an example. The
screen depends on the model type.)
Six swash types are available for helicopters.
Six types of main wings and three types of tail
wings are available for airplanes and gliders.
Functions and mixing functions necessary for each
model type are set in advance at the factory.
Note: The Model Type function automatically
selects the appropriate output channels,
control functions, and mixing functions for the
chosen model type.
When the Model Type selection command
is accessed, all of the data in the active
memory is cleared (except the following
swash type.) Be sure that you don’t mind
losing this data, or back it up to another
memory using the copying functions.
When changing the helicopter swash type
within the following groups, you can leave
the settings other than the SWASH function.
However, this is initialized when you change
the swash type to the other swash type
group.
Model type selection
1.Movethecursortotheitemyouwantto
changeandpushtheRTNbuttontoswitch
tothedatainputmode.
 SelectthedesiredtypebyscrollingthePush
dialandpushtheRTNbutton.Aconrmation
messageappears.PushtheRTNbuttonfor
onesecond.
 Moveto[YES]andPushtheRTNbuttonfor
onesecond.
 (Toterminateinputandreturntotheoriginal
state,pushtheS1buttonorselect[NO]and
pushtheRTNbutton.)
 "TYPE":Modeltype
 "WING"(airplane/glider):Wingtype
 "TAIL"(airplane/glider):Tailtype
 "SWASH"(helicopter):Swashtype
*The wing types which can be selected depend on the mode;
T-FHSS Air or S-FHSS.
●Select[MODELTYPE]intheLinkagemenuand
accessthesetupscreenshownbelowbypushing
theRTNbutton.
2.Ifresettingthedatawhenchangingthe
helicopterswashtype:
(Helicopter)
 Movethecursorto[OFF]andpushtheRTN
buttontoswitchtothedatainputmode.
 Select[ON]byscrollingthePushdialand
pushtheRTNbutton.Aconrmationmessage
appears.PushtheRTNbutton.
 Activatetheswashtypesetting.Theswash
settingparametersarereset.
Swash type group A:
H-1,H-3,HR3,andHE3
Swash type group B:
H-4,H-4X
Scrolling
●Movingcursor
●Selectingmode
●Toinputdatamode
●Dataisentered