FUTABA T12K

151
<Model Menu (Airplane/Glider/Multirotor Functions)>
●Selectthefunctionname
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
<Push Dial>
RETURN
ELEVATOR
ELEVATOR 2
V-TAIL
ELEVATOR
ELEVATOR 2
AILEVATOR
FLP 2
(Camber Flap)
FLP 1
(Camber Flap)
CMBFLP to ELE
[Correspondingmodeltype]:Airplane/glider,
2ailerons+1apormore
When the camber/speed flaps are utilized,
the aircraft might experience a change in pitch.
This mix compensates for such changes by
incorporating elevator input.
●Theelevatorservos'up/downratescanbe
adjustedseparately.Ifthemixingdirectionis
reversed,changethemixingratepolarity(+or–).
●MixingduringflightcanbeturnedON/OFFby
settingaswitch.(AlwaysONat[--]setting)
●Elevatorrate
adjustment
Setting method
●Activate the function
 Movethecursortothe[ACT]itemandpush
the RTN button to switch to the data input
mode.SelecttheACTmodebyscrollingthe
Pushdial.
*The display blinks.
 PushtheRTNbuttontoactivatethefunction
andreturntothecursormode.(ONis
displayed.)
When setting a switch, move the cursor to
the[SW]itemandpushtheRTNbuttontocall
theselectionscreen.Selecttheswitchand
setitsONdirection.(AlwaysONat"--"setting)
*For a description of the switch selection method, see the
description at the back of this manual.
●Mixing rate adjustment
 MovethecursortotheRATE1orRATE2item
and push the RTN button to switch to the
datainputmode.Adjustthemixingrate
independentlybyscrollingthePushdial.
 Initialvalue:0%
 Adjustmentrange:-120~+120%
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
 PushtheRTNbuttontoendtheadjustment
and return to the cursor mode.
●Select[CMBFLPtoELE]attheModelmenuand
access the setup screen shown below by pushing
the RTN button.
*The display screen is an
example. The actual screen
depends on the model type.
(Glider: Currently selected condition name)
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Toinputdatamode
●Dataisentered