FUTABA T12K

152
<Model Menu (Airplane/Glider/Multirotor Functions)>
If operational mode is changed, a mixing
rate will become an initial value (0%).
The image of each
rate of operation
It operates as curve
mixing of three
points according
to the operative
position of the ap.
【
Mode B
】 (3 Points curve mixing )
・ The master of this mixing is the control hardware of Camber
FLAP.
The rate which is operating is shown. Two ↓
may be displayed when the lever and the dial
are set to operation of a camber ap. In that
case, it operates linearly between rates with ↓
display.
The amount of ELE operations
FLP operative position
RATE 1
RATE 2
RATE 3
-100%
+100%
0%
◆ Mode A ･･･ Compatible to conventional 2 rates mixing.
◆ Mode B ･･･ 3 Points curve mixing.
If operational mode is changed, a mixing
rate will become an initial value (0%).
【
Mode A
】 (Compatible to conventional 2 rates mixing.)
・ The master of this mixing is output of Camber FLAP D/R.
Mixing rate
Range : -120 ～ +120%
The rate which is
operating is shown.
Camber FLP to ELE ModeA ModeB
3pointscurvemixingsimilartoD/RisaddedtoCamberFLP
toELEmixingfunction.Itisaneasywaytosettheamountof
movingELEwhenFLPisdown.