SBUS servo setting.
An S.BUS servo can memorize the channel
and various settings you input. Servo setting
can be performed on the T12K screen by
wiring the servo as shown in the figure.
● Select [SOUND] at the system menu and access
the setup screen shown below by pushing the RTN
button.
Servo ID number
Individual ID numbers are memorized for your
S.BUS(2) servos in your T12K. When a servo is
used, the servo ID number is automatically read by
the transmitter.
If you use multiple S.BUS(2) servos
and do not want to change the settings on all that are
mounted in a fuselage, only the desired servo in the
group can be set by entering the ID of that specic
servo.
* With some S.BUS(2) servos, there are some functions which
cannot be used. If a function cannot be used, the display screen
will change.
(Only the function which can be used by a servo is displayed.)
* After reading completion, with connection of the above
gure, if a stick is moved, the test of operation of the servo
can be operated and carried out.
Procedure for changing S.BUS servo setting
1. Select [SBUS SERVO] of the System Menu.
2. Wire the servo as shown in the gure above.
3. Push [RECALL] on page 3(S1 is pushed twice).
The ID and current setting of that servo are
displayed. ([RECALL] is chosen
⇒
RTN is
pushed
⇒
RTN is pushed for 1 second)
4. When multiple servos are connected change
[INH] at the right side of the ID number on the
screen to [ACT] and enter the ID of the servo
you want to set.
5. Set each item. (Please see the next page.)
6. Push [WRITE] on page 3([WRITE] is chosen
⇒
RTN
is pushed
⇒
RTN is pushed for 1 second). The
settings are changed.
Push [INIT.], if you would like to initialize a
setup of a servo. ([INIT.] is chosen
⇒
RTN is
pushed
⇒
RTN is pushed for 1 second)
S.BUS/S.BUS2
Servo
Battery
T12K
3-way hub
or
Y-harnesses
SBUS SERVO
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To next page
● To input data mode
● Data is entered
To Next Page
Loading...
