FUTABA T12K

123
<Functions of Linkage Menu>
●Selectthefunctionname
andreturntotheLinkage
menubypushingthe RTN
buttonor pushingthe
HOME/EXITbutton.
<Push Dial>
RETURN
●Callpage7bypushingtheS1button6timesfrom
the[SENSOR]menu.
SENSOR : RELOAD
SENSOR : REGISTER
This page is set when using multiple telemetry sensors of the same type.
This page is set when using multiple telemetry sensors of the same type.
When using multiple sensors of the same type
the sensors must be registered in the transmitter.
Connect all the sensors to be used to the T12K as
shown in the gure at the right and register them by
the following procedure. The ID of each sensor is
registered in the transmitter.
This function registers an additional sensor.
Connect the sensor as shown in the figure at the
right and register it by the following procedure.
The sensor ID is registered in the transmitter.
All the sensors to be used are connected.
SENSOR SENSOR
3-way hub
or Y-harnesses
Receiver's
battery
SENSOR SENSOR SENSOR
3-way hub
or Y-harnesses
Receivers
battery
SENSOR
Reading all the sensors to be used
1.Connectallthesensorsandreceiver
batteriestobeusedtotheT12Kthrougha
hubasshowninthegureabove.
2.Movethecursorto“RELOAD”onpage7of
the[SENSOR]screen.
3.PushtheRTNbutton.
Allthesensorsareregisteredandcanbe
used.
Additional sensor registration
1.Connectthesensorandreceiverbatteryto
beusedtotheT12Kthroughahubasshown
inthegureattheright.
2.Movethecursorto“REGISTER”onpage7of
the<Sensor>screen.
3.PushtheRTNbutton.
Thesensorisregisteredandcanbeused.
*
When the number of slots needed in registration is
insufcient, an error is displayed and registration cannot be
performed. Disable unused slots or perform the following
relocate.
Scrolling
●Movingcursor
●Tonextpage
●Dataisentered