FUTABA T12K

89
<Functions of Linkage Menu>
●Selectthefunctionname
andreturntotheLinkage
menubypushingthe RTN
buttonor pushingthe
HOME/EXITbutton.
<Push Dial>
RETURN
IDLE DOWN
Lowerstheengineidlingspeed(airplaneonly)
The Idle Down function lowers the engine to
its idle position. Like throttle cut, this is usually
accomplished by ipping a switch with the throttle
stick at idle. The action is not functional at high
throttle to avoid accidental dead sticks. The
switch’s location and direction must be chosen, as
it defaults to NULL.
Idle down setting procedure
1.Activatethefunction:
 Movethecursortothe[ACT]itemandpush
theRTNbuttontoswitchtothedatainput
mode.
 SelecttheACTmodebyscrollingthePush
dial.
*The display blinks.
 PushtheRTNbuttontoactivatethefunction
andreturntothecursormode.
2.Switchselection:
 Movethecursortothe[SW]itemandaccess
theswitchsetupscreenbypushingtheRTN
button.SelecttheswitchandONdirection.
*For a detailed description of the setting method, see [Switch
Setting Method] at the back of this manual.
3.Offsetratesetting:
 Movethecursortothe[OFFSET]itemand
pushtheRTNbuttontoswitchtothedata
inputmode.
 Adjusttheservooffsetrateatidledown
operationbyscrollingthePushdial.
 Initialvalue:0%
 Adjustmentrange:-100%~0%~+100%
* When a minus rate is input, an offset is applied at the high
side.
*Maximum offset amount is near maximum slow.
* When the RTN button is pushed for one second, the offset
rate is reset to the initial value.
 PushtheRTNbuttontoendtheadjustment
andreturntothecursormode.
●Select[IDLEDOWN]intheLinkagemenuand
accessthesetupscreenshownbelowbypushing
theRTNbutton.
●Currentthrottleposition
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Toinputdatamode
●Dataisentered