FUTABA T12K

144
<Model Menu (Airplane/Glider/Multirotor Functions)>
●Selectthefunctionname
and return to the Model
menu by pushing the RTN
button or pushing the
HOME/EXIT button.
<Push Dial>
RETURN
AIL 3
(Chip Aileron)
AIL 4
(Chip Aileron)
AIL1
(Main Aileron)
AIL 2
(Main Aileron)
FLP 3
(Brake Flap)
FLP 4
(Brake Flap)
AIL to BRAKEFLP
[Correspondingmodeltype]:Glider,4aps
This mix operates the brake flaps (FLP3/4)
in the aileron mode. When the aileron stick is
manipulated, the aileron and brake aps perform
the aileron operation simultaneously and the roll
axis is improved.
●Theaileronleftandrightmixing ratescanbe
adjustedseparatelyforeachapservo.
●MixingduringflightcanbeturnedON/OFFby
settingaswitch.(AlwaysONat[--]setting)
●Linkingcanbeset:Linkthismixtoothermixes.
●Select[AILtoBRKFLP]attheModel
menu and access the setup screen
shown below by pushing the RTN
button.
●Adjustmentofeach
apservo
*The display screen is an example. The actual
screen depends on the model type.
(Currently selected condition name)
Setting method
●Activate the function
 Movethecursortothe[ACT]itemandpush
the RTN button to switch to the data input
mode.SelecttheACTmodebyscrollingthe
Pushdial.
*The display blinks.
 PushtheRTNbuttontoactivatethefunction
andreturntothecursormode.(ONis
displayed.)
When setting a switch, move the cursor
tothe[SW]itemandpushtheRTNbutton
toaccesstheselectionscreen.Selectthe
switchandsetitsONdirection.(AlwaysON
at"--"setting)
*For a description of the switch selection method, see the
description at the back of this manual.
●Mixing rate adjustment
 Movethecursortotheflap(FLP)3~4leftor
right item and push the RTN button to switch
tothedatainputmode.Adjustthemixing
rateindependentlybyscrollingthePushdial.
 Initialvalue:0%
 Adjustmentrange:-120~+120%
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
 PushtheRTNbuttontoendtheadjustment
and return to the cursor mode.
●Link mode setting
To activate the mixing, move the cursor to
the[LINK]itemandpushtheRTNbuttonto
switchtothedatainputmode.Selectthe
ONmodebyscrollingthePushdial.
*The display blinks.
 PushtheRTNbuttontosetthelinkmodeand
return to the cursor mode.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Toinputdatamode
●Dataisentered