FUTABA T12K

169
<Model Menu (Airplane/Glider/Multirotor Functions)>
<Push Dial>
FLT. MODE
[Correspondingmodeltype]:Multirotor
In the FLT. MODE (flight mode), you can
change the multicopter mode to up to 3 CH, 5
signals set with any switch. It is used in the case of
a multicopter controller of the type that can change
the ight mode.
Setting method
●Function setting
 Assignthechanneltobeusedwiththe
functionofthelinkagemenu(MODE/
MODE2/MODE3).
●Rate adjustment
 MovethecursortotheFM1-FM5/MODE-
MODE3itemforeachdirectionandpushthe
RTN button to switch to the data input mode.
Adjusttherateindependentlybyscrolling
thePushdial.
 Initialvalue:0%
 Adjustmentrange:-150~+150%
●Select[FLT.MODE]attheModelmenu
and access the setup screen shown
below by pushing the RTN button.
●Select[FUNCTION]attheLinkagemenuandaccessthe
setup screen shown below by pushing the RTN button.
●Switchselection
● MODE
● MODE2
● MODE3
Initialvalue:
0%
Adjustmentrange:
-150%
～
150%
●Settheflightmode
selection switch. When
FM2toFM5areallOFF,
FM1isselected.
●AssignMODEtothe
channel to be used for
ightmodeinadvance.
●ACT/INH
ON during operation
PriorityHigh
PriorityLow
●Itispossibletoset3functionsof"MODE""MODE2"
"MODE3".
●Fivetypesofflightmodesettingsare possiblefor
each function.
●Thesettingrangeis-150%(about890
µ
S)to+150%
(about2150
µ
S)
●Thepriorityoftheightmodeis
FM1<FM2<FM3<FM4<FM5
●Itwillnotworkifanyfunctionof"MODE""MODE2"
"MODE3"isnotset.
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
 PushtheRTNbuttontoendtheadjustment
and return to the cursor mode.
●Switch selection
Move the cursor to the switch item and
push the RTN button to access the selection
screen.SelecttheswitchandsetitsON
direction.
*For a description of the switch selection method, see the
description at the back of this manual.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Toinputdatamode
●Dataisentered