FUTABA T12K

80
<Functions of Linkage Menu>
●Selectthefunctionname
andreturntotheLinkage
menubypushingthe RTN
buttonor pushingthe
HOME/EXITbutton.
<Push Dial>
RETURN
System Type selection
The T12K is for 2.4GHz only. The system can
be changed from among 2 choices: T-FHSS Air
(12CH+ON/OFF-2CH) and S-FHSS (8CH).
*If you change the System Type, other model data is not
reset.
*If a system type is changed in helicopter mode, the
transmitter will offer two selections:
[Yes] : Selection sets the channel order suitable for System
Type. (We recommend here. )
[No] : The present channel order is maintained.
*After any change, remember to test the model and should
fully check servo direction and a motion.
SYSTEM
Systemmodesetting,Receiverlink
Battery fail-safe voltage setup (only T-FHSS Air )
The voltage which battery fail-safe activates,
can be set when you link. (3.5-8.4V) The receiver
memorizes the setting as it was at link.
Suggested setting voltages are as follows.
• 4 cells NiCd or NiMH (Normal: 4.8v) = 3.8 v
• 2 cells LiFe (Normal: 6.6 v) = 6.0 ~ 6.2 v
• 2 cells LiPo (Normal: 7.4 v) = 7.2 ~ 7.4 v
It is a rough reference value.
Since it changes with servos carried in the
condition and the model of a battery, please set to
your own model in a battery consumption current.
Receiver linking
The receiver will only be controlled (without
being affected by other transmitters) by the
transmitter it is linked to. When using a receiver
other than one purchased as a set, linking is
necessary.
Moreover, a re-link is required when a new
model is added by model selection, and the time of
system type change.
●Select[SYSTEM]intheLinkagemenuandaccess
thesetupscreenshownbelowbypushingthe
RTNbutton.
P.42
Linking method
Cases when linking is necessary:
・
Whenusingareceiverotherthantheinitialsetting.
・
Whenthecommunicationsystemwas changed.
(T-FHSSAir
↔
S-FHSS
)
・
Whenanewmodelwascreatedbymodel
selection.
System Type selection procedure
1.Movethecursortothe[T-FHSS]itemand
pushtheRTNbuttontoswitchtothedata
inputmode.
2.SelectthesystemtypebyscrollingthePush
dial.
 [T-FHSS]or[S-FHSS]
3.PushtheRTNbuttontoendadjustmentand
returntothecursormode.
Telemetry function (T-FHSS Air mode only)
To use the telemetry function, set “Telemetry”
to “ACT”.
●InthecaseofT-FHSS,the
IDofthelinkedreceiver
isdisplayed.
System T-FHSS Air S-FHSS
CH 12CH+ON/OFF2CH 8CH
Telemetry Possible Impossible
Receiver
(2017,11)
R3006SB
R3008SB
R3001SB
R2006GS
R2106GF
R2008SB
R2001SB
*Thesurfacesystem
receiversreceiver
cannotbeused.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Toinputdatamode
●Dataisentered