FUTABA T12K

180
<Functions of Model Menu (Helicopter Functions)>
●Selectthefunctionname
andreturntotheModel
menubypushingthe RTN
buttonor pushingthe
HOME/EXITbutton.
<Push Dial>
RETURN
PIT to RUD mixing (Revolution mixing)
Use this mix when you want to suppress the
torque generated by main rotor pitch and speed
changes during pitch operation. Adjust so that the
nose does not move in the rudder direction.
<Normal condition mixing curve>
 Themixingcurverateshouldbestarted
usingsmallervalues.
 Forarotorwithaclockwiseoperation
direction,whenpitchwasinputattheplus
side,settheseparameterssothatmixing
isintheclockwisedirection.First,trimat
hoveringandthenadjusttheneutral
position.
1.Adjustmentbetweenslowandhovering
 Repeatedlyhoverfromtakeoffandland
ataconstantratematchedtoyourown
rhythm.Adjustthepitchsothatthenose
ofthehelicopterremainssteadywhenthe
throttleisraisedandlowered.
2.Throttlehighside(climbinganddiving
fromhovering)
 Repeatclimbinganddivingfromhovering
ataconstantratematchedtoyourown
rhythmandadjustthepitchsothatthe
nosedoesnotdeflectwhenthethrottleis
raisedandlowered.
Note: When a GY Series or other heading hold
gyro is used, since correction is performed by
the gyro, this mix is not utilized. If this function
is used when the gyro operation mode is the
AVCS mode, the neutral position will change.
<Idle up condition mixing curve>
 Setthemixingratesothattherudderdirection
athigh-speedightisstraightahead.Adjustfor
eachconditionused.
●Select[PITtoRUD]attheModelmenuandaccess
thesetupscreenshownbelowbypushingthe
RTNbutton.
(Currently selected condition name)
Setting method
●Activate the mixing
 Whenusingthisfunction,movethecursorto
the[ACT]itemandpushtheRTNbuttonto
switchtothedatainputmode.
 SelecttheACTmodebyscrollingthePush
dial.
*The display blinks.
 PushtheRTNbuttontoactivatethemixing
andreturntothecursormode.(ONis
displayed.)
●5-point curve setting
 Movethecursortothecurveratesetting
itemyouwanttoadjustandpushtheRTN
buttontoswitchtothedatainputmode.
 AdjusttheratebyscrollingthePushdial.
 Initialvalue:P1~P5:0%
 Adjustmentrange:-100%~+100%
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
 PushtheRTNbuttontoendtheadjustment
andreturntothecursormode.
 Repeatthisprocedureforeachpoint.
●Pitch curve copy function
 MovethecursortoCOPYitemandpushthe
RTNbuttontoswitchtothedatainputmode.
Selectthecopydestinationconditionby
scrollingthePushdialandpushingtheRTN
button.Selectthe[YES]andpushtheRTN
button.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Toinputdatamode
●Dataisentered