EasyManua.ls Logo

FUTABA T12K

FUTABA T12K
192 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
96
<Functions of Linkage Menu>
●Selectthefunctionname
andreturntotheLinkage
menubypushingthe RTN
buttonor pushingthe
HOME/EXITbutton.
<Push Dial>
RETURN
WARNING
Lowbatteryalarmvoltagesetwarningnormalreset
The T12K includes an audible alarm that sounds
when the transmitters battery voltage drops below
a pre-determined setting; adjustable for cell types
and voltages.
Mixing warning at power ON can be reset to
OFF.
Accessing and Activating the Low Battery
Alarm
1.Thelowbattery(LOWBATTERY)alarmvoltage
isaccessedthroughtheT12K’sSystemMenu.
WithintheSystemMenu,usethePushDialto
highlightthesoundoptionandthenpushthe
return(RTN)buttontoconrmtheselection.
2.UsethePushDialtoscrolltothelowbattery
(LOWBATTERY)alarm,andthenpushthe
return(RTN)buttontoaccessthevoltage
settings.UsingthePushDial,adjustthe
voltageasdesiredand/ordeterminedby
thetransmitterbatterypackbeingutilized.
Thevoltageoptionsrangefrom4.2Vto7.4V.
Suggestedvoltagesettingsareasfollows:
5-Cell NiCd or NiMH: 5.6V
2-Cell LiFe: 6.0V
Warning normally resetting method
1.Movethecursortotheitemyouwantto
resettoOFFandpushtheRTNbuttonto
switchtothedatainputmode.
2.SelecttheOFFmodebyscrollingthePush
dial.
*The display blinks.
3.PushtheRTNbutton.(Toterminatetheinput
andreturntotheoriginalstate,pushtheS1
button.)
Warning display:
Airplane:Throttlecut/Idledown/Throttle
position/Snap-roll/Motorposition/Airbrake/
Motor
Helicopter:Condition/Throttlecut/Throttle
position/ThrottleHold
Glider:Condition/Motorposition/Trim-mix/Motor
●Select[WARNING]intheLinkagemenuand
accessthesetupscreenshownbelowbypushing
theRTNbutton.
●PushS1buttontoadvancetonextpage.
*Regarding low battery voltage: All models included in one
12K transmitter will be changed together. The voltage cannot
be set to a separate value for each model, nor will data reset
be carried out.
TYPE 1
TYPE 2
TYPE 3
TYPE 4
"Vibes" type
Ifthefollowingtypesareselected,thetransmitterwill
vibrateduringthewarning.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
●Toinputdatamode
●Dataisentered

Table of Contents

Other manuals for FUTABA T12K

Related product manuals