FUTABA T12K

104
<Functions of Linkage Menu>
●Selectthefunctionname
andreturntotheLinkage
menubypushingthe RTN
buttonor pushingthe
HOME/EXITbutton.
<Push Dial>
RETURN
TELEMETRY : Rx-BATT.
Displayingdatafromthereceiverbatteryvoltage
In this screen, the battery voltage of a receiver is
displayed.
If it becomes higher or lower than the setting an
alarm and/or vibration will alert you.
*It cannot be used in S-FHSS mode
●Select[Rx-BATT.]intheTELEMETRYscreenand
accessthesetupscreenshownbelowbypushing
theRTNbutton.
●Receiverbatteryvoltage
●Themaximumandtheminimumwhen
poweringONareshown.
●↓The"down"arrowwill
indicatethatanalarmwill
soundwhenthevoltage
dropstobelowthesetting.
Alert set
1.Movethecursortothe↓ALERT[INH]itemand
pushtheRTNbuttontoswitchtothedata
inputmode.
2.SelecttheACTmodebyscrollingthePush
dial.
3.PushtheRTNbutton.(Toterminatetheinput
andreturntotheoriginalstate,pushtheS1
button.)
4.Movethecursortothe↓THRESHOLD[4.0V]
itemandpushtheRTNbuttontoswitchto
thedatainputmode.
5.AdjusttheratebyscrollingthePushdial.
 Initialvalue:4.0V
 Adjustmentrange:0.0V~8.4V
*When the RTN button is pushed for one second, the rate is
reset to the initial value.
6.PushtheRTNbutton.(Toterminatetheinput
andreturntotheoriginalstate,pushtheS1
button.)
TYPE 1
TYPE 2
TYPE 3
TYPE 4
"Vibes" type
Ifthefollowingtypesareselected,thetransmitterwill
vibrateduringthewarning.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
●Toinputdatamode
●Dataisentered