FUTABA T12K

95
<Functions of Linkage Menu>
●Selectthefunctionname
andreturntotheLinkage
menubypushingthe RTN
buttonor pushingthe
HOME/EXITbutton.
<Push Dial>
RETURN
STK ALARM
Stickalarm
An alarm (single beep) can be sounded at the
specied stick position.
●AlarmfunctionON/OFFcanbesetbyswitch.
●Select[STKALARM]intheLinkagemenuand
accessthesetupscreenshownbelowbypushing
theRTNbutton.
100%
100%
J4 0%
0%
J3
100%
100%
J1 0%
0%
J2
Stick alarm setting procedure
1.Activatethefunction:
 Movethecursortothe[ACT]itemandpush
theRTNbuttontoswitchtothedatainput
mode.
 SelecttheACTmodebyscrollingthePush
dial.
*The display blinks.
 PushtheRTNbuttontoactivatethefunction
andreturntothecursormode.
2.Switchselection:
 Movethecursortothe[SW]itemandaccess
theswitchsetupscreenbypushingthe
RTNbuttonandselecttheswitchandON
direction.
*For a detailed description of the setting method, see [Switch
Setting Method] at the back of this manual.
3.Stickselection:
 Movethecursortothe[STK]itemand
pushtheRTNbuttontoswitchtothe
datainputmode.
 SelectthestickbyscrollingthePushdial.
4.Alarmpositionsetting:
 Movethecursortothe[POS]item.
 Adjustthepositionbyselectstick.
 PushtheRTNbutton.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Toinputdatamode
●Dataisentered