As with all radio frequency transmissions,
the strongest area of signal transmission is from
the sides of the transmitter antenna. As such,
the antenna should not be pointed directly at the
model. If your ying style creates this situation,
easily move the antenna to correct this situation.
LED
• Off
Radio waves are in the OFF state.
• On
Radio waves are being transmitted.
• Blinking
Power switch is turned on when any
condition switch is activated (in the ON
state).
Monitor LED display
Transmitter status is displayed by LEDs.
Rotating antenna
The antenna can be rotated 180 degrees and
angled 90 degrees. Forcing the antenna further
than this can damage it. The antenna is not
removable.
Caution
Please do not grasp the transmitter
antenna during ight.
Doing so may degrade the quality of the RF
transmission to the model
Do not carry the transmitter by the
antenna.
This could damage the antenna and render the
transmitter inoperable.
Do not pull the antenna forcefully.
This could damage the antenna and render the
transmitter inoperable.
Low power
High power High power
Do not point the tip of the
antenna at a flying model,
this reduces signal quality.
If you want to point your
transmitter at a model, bend
the antenna 90 degrees for
best signal strength.
180°
90°
Transmitter Antenna
To Next Page
Loading...
