FUTABA T12K

168
<Model Menu (Airplane/Glider/Multirotor Functions)>
Setting method
●Master/single mode selection
 Movethecursortothe[MODE]itemand
push the RTN button to switch to the data
inputmode.Selectthemasterorsingle
modebyscrollingthePushdial.
*The display blinks.
 [MASTER]:Mastermode
 [SINGLE]:Singlemode
 PushtheRTNbuttontoselectthemodeand
return to the cursor mode.
When setting a master switch, move the
cursortothe[MASTER-SW]itemandpushthe
RTN button to access the selection screen.
SelecttheswitchandsetitsONdirection.
*For a description of the switch selection method, see the
description at the back of this manual.
When setting a safety switch, move the
cursortothe[SAFETY-SW]itemandpushthe
RTN button to access the selection screen.
SelecttheswitchandsetitsONdirection.
●Direction switch selection
Move the cursor to the direction switch
item and push the RTN button to access the
selectionscreen.Selecttheswitchandsetits
ONdirection.
*For a description of the switch selection method, see the
description at the back of this manual.
●Rate adjustment
Move the cursor to the aileron, elevator or
rudder item for each direction and push the
RTN button to switch to the data input mode.
Adjusttherateindependentlybyscrolling
thePushdial.
 Initialvalue:(Dependentuponthesnaproll
direction)
 Adjustmentrange:-150~+150%
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
 PushtheRTNbuttontoendtheadjustment
and return to the cursor mode.