SBD-1 CH setting
CH setting of SBD-1 is available.
The
SBD-1
(option) is a converter for using
conventional servos (other than
S.BUS
servo) with
the
S.BUS
system.
1. Connect the SBD-1 and the battery to S.I/F
port with 3 ways hub or Y harness.
2. Select S.BUS SERVO menu in SYSTEM menu.
3. Move to page 3/3.
4. Operate RECALL button. (RECALL is chosen.
⇒
RTN is pushed.
⇒
RTN is pushed for 1
second.)
SBD-1 setting screen is shown.
5. Set CH to each port of SBD-1. (SX1, SX2 and
SX3)
* Setting range : CH1
～
CH12
，
DG1
，
DG2
6. Operate WRITE button. (WRITE is chosen.
⇒
RTN is pushed.
⇒
RTN is pushed for 1 second.)
7. The settings are changed.
8. When the WRITE operation is successful, the
message "COMPLETED" is shown.
9. When the WRITE operation fails, the message
"FAILED" is shown.
WRITE operation is writing
CH settings to SBD-1.
RECALL operation is reading
CH settings from SBD-1.
To Next Page
Loading...
