FUTABA T12K

154
<Model Menu (Airplane/Glider/Multirotor Functions)>
Setting method
●Activate the function
 Movethecursortothe[ACT]itemandpush
the RTN button to switch to the data input
mode.SelecttheACTmodebyscrollingthe
Pushdial.
*The display blinks.
 PushtheRTNbuttontoactivatethefunction
andreturntothecursormode.(ONis
displayed.)
When setting a switch, move the cursor to
the[SW]itemandpushtheRTNbuttontocall
theselectionscreen.Selecttheswitchand
setitsONdirection.(AlwaysONat"--"setting)
*For a description of the switch selection method, see the
description at the back of this manual.
●Rate adjustment
Move the cursor to the aileron, flap or
elevator rate item and push the RTN button
toswitchtothedatainputmode.Adjustthe
rateindependentlybyscrollingthePushdial.
 Initialvalue:0%
 Adjustmentrange:-200~+200%(Elevator:
-120~+120%)
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
 PushtheRTNbuttontoendtheadjustment
and return to the cursor mode.
● Elevator compensation curve adjustment
Output(Y) Position(X)
Offsetpoint Fixed(0) Fixed(offset
position)
2-Intermediatepoint Settable Settable
1-Endpoint Settable Fixed
* The range where mixing does not work close to the neutral
position of the elevator stick can be adjusted. (Glider only)
*When offset is set, the curve is initialized.
●Reference point adjustment
 Movethecursortothe[OFFSET]itemand
hold the airbrake stick to the desired position.
Then, push the RTN button for one second to
setthebutteryoperationalreferencepoint.
 Initialvalue:15%(upperside)
 Adjustmentrange:0~100%
●Servo speed setting
Move the cursor to the aileron, flap or
elevator speed item and push the RTN button
to switch to the data input mode.
 AdjusttheratebyscrollingthePushdial.
 Initialvalue:0
 Adjustmentrange:0~27(maximumdelay)
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
 PushtheRTNbuttontoactivatethefunction
and return to the cursor mode.
The ne
tune control
hardware
Operation Mode
When the ne tune control is set, it is
displayed.
Mode : LIN. / ATL+ / ATL- / SYM.
The ne tune rate
Range ： -100 ～
+100%
Actual rate
Fine Tune Control
*When Flying wing type, it was made not to display
BUTTERFLY ELE. (There is no elevator rate setting .)
●Fine tune