FUTABA T12K

158
<Model Menu (Airplane/Glider/Multirotor Functions)>
Setting method
●Activate the function
 Movethecursortothe[ACT]itemandpush
the RTN button to switch to the data input
mode.SelecttheACTmodebyscrollingthe
Pushdial.
*The display blinks.
 PushtheRTNbuttontoactivatethefunction
andreturntothecursormode.(ONis
displayed.)
When setting a switch, move the cursor to
the switch item and push the RTN button
toaccesstheselectionscreen.Selectthe
switchandsetitsONdirection.(AlwaysON
at"--"setting)
*For a description of the switch selection method, see the
description at the back of this manual.
●Offset rate adjustment
 Movethecursortotheaileron,ap,rudderor
elevator rate item and push the RTN button
toswitchtothedatainputmode.Adjustthe
rateindependentlybyscrollingthePushdial.
 Initialvalue:0%
 Adjustmentrange:-250~+250%
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
 PushtheRTNbuttontoendtheadjustment
and return to the cursor mode.
●Servo speed setting
Move the cursor to the aileron, flap, rudder
or elevator speed item and push the RTN
button to switch to the data input mode.
 AdjusttheratebyscrollingthePushdial.
 Initialvalue:0
 Adjustmentrange:0~27(maximumdelay)
*When the RTN button is pushed for one second, the rate is
reset to the initial value.)
 PushtheRTNbuttontoreturntothecursor
mode.
●Auto switch selection
When setting a auto switch, move the cursor
tothe[AUTO-SW]itemandpushtheRTN
buttontoaccesstheselectionscreen.Select
theswitchandsetitsONdirection.(Always
ONat"--"setting)
*For a description of the switch selection method, see the
description at the back of this manual.
The screen of O󱐯set mode
The operation hardware is set.
The default setting is below;
Stick Mode 1 : J2
Stick Mode 2 : J3
●Linear mode
InLinearMode,Airbrakeisoperatedbythe
stick or lever.
The start point of the mixing can be set.
Mode button
OFS :
O󱐯set mode
LIN :
Linear mode
The start point this mixer is set.
< > is current position of MASTER.
At J1, J4, LD and RD, the left end
point is 0%, the right end point is
100%.
At J2, J3, LS, RS and SA~SH, the
upper end point is 100%, the lower
end point is 0%
Operated by the
stick or lever
Low side Airbrake moves
Airbrake
doesn't move.
Air brake moves in
linear
e.g. Start point
J3:
＜
50%
＞