FUTABA T12K

136
<Model Menu (Airplane/Glider/Multirotor Functions)>
AIL 3
(Chip Aileron)
AIL 4
(Chip Aileron)
AIL1
(Main Aileron)
AIL 2
(Main Aileron)
FLP 2
(Camber Flap)
FLP 1
(Camber Flap)
ELEVATOR
(ELEVATOR 2)
V-TAIL AILVATOR
FLP 3
(Brake Flap)
FLP 4
(Brake Flap)
RUDDER 2
Winglet
RUDDER 1
RUDDER
(RUDDER 2)
Winglet
at Flying wing at Flying wing
( )
( )
ELEVATOR
ELEVATOR 2
(AILERON 5)
(AILERON 6)
AIL to RUD
This mix is used when you want to coordinate
the rudder with aileron operation for banking at
shallow angles. [Airplane/glider, general]
RUD to AIL
This function is used when you want to mix
the ailerons with rudder input. Rudder is applied
during rolling maneuvers such as knife edge
ight. [Airplane/glider, general]
CAMBER MIX
This mix adjusts the camber and corrects the
elevators. [Airplane/glider, 2 ailerons or more]
ELE to CAMBER
This mix is used when you want to mix
camber aps with elevator to increase the lift of
the model. [Airplane/glider, 2 ailerons or more]
CAMB.FLP to ELE
This mix is used to correct for changes in
attitude when the camber flaps are utilized.
[Airplane/glider, 2 ailerons + 1 ap or more]
BUTTERFLY (Crow)
This function is used to quickly slow the
aircraft and/or reduce the altitude. [Glider, 2
ailerons or more (Flying: 2 ailerons + 1 flap or
more)]
TRIM MIX
The ailerons, elevators, and flaps trim offset
rate can be accessed by selecting a switch or
condition selection as desired. [Glider, 2 ailerons
or more]
AIRBRAKE
This function is used when airbrakes are
necessary when landing or when diving, etc.
during ight. [Airplane, 2 ailerons or more]
GYRO
This is a dedicated mix when a GYA Series
gyro is used. [Airplane/glider/multirotor, general]
V-TAIL
This function incorporates the elevators and
rudder input for use with V-tail models. [Airplane/
glider, V-tail specications]
AILEVATOR (DUAL ELEVATOR)
This function adjusts the elevators and ailerons
of models with elevator specications. [Airplane/
glider, ailevator specications]
WINGLET
This function adjusts the left and right rudders
of winglet models. [Airplane/glider, winglet
specications]
MOTOR
This function adjusts the operation speed when
the motor of an F5B or other such EP glider is
started by a switch. [Airplane/glider, general]
RUD to ELE
This function is used to correct rolling
maneuvers, such as knife edge ight. [Airplane,
general]
SNAP ROLL
This function selects the snap roll switch and
adjusts the amount of servo input. Servo speed
can also be adjusted. [Airplane general]
FLIGHT MODE
This function selects 5 flight modes.
[Multirotor]