FUTABA 6XA - Idle-Up and Throttle Hold; Dual Rates and Trim Memory

HELICOPTER (HELI) MENU FUNCTIONS
The following section (pages 43 – 54) describes how to use the helicopter-specific menu
functions for helicopters (model types HELI). Descriptions of the other functions are contained in
the aircraft (ACRO) section which precedes this one, pages 14 –42.
Helicopter Functions Map......................................................43
Helicopter Setup Example......................................................45
Helicopter Trimming Chart....................................................48
P-AT.............Pitch Adjustable Travel Volume .....................49
HV-T ............Hovering Throttle ............................................49
IDLE.............Idle-Up function...............................................50
HOLD...........Throttle Hold ...................................................51
REVO...........Revolution mixing...........................................51
R-OF.............Rudder Offset...................................................52
HV-P.............Hovering Pitch.................................................53
SWSH...........Swashplate Type & AFR.................................53
– 45 –
T6XAS/HS Helicopter Mode Menu [HELI]
Normal Display Mode
Press both Mode
Select keys
(HELI functions have bold boundaries)
Throw Adjust [ATV]
Dual Rate Set [D/R]
Exponential [EXP]
Servo Reverse [REV]
Sub-Trims [STRM]
Pitch ATV [P-AT]
Memory Reset [REST]
Dual Rate Sw. [DRSW]
Select Model Type [ACRO]
Select Model Type [HELI]
Modulation: PCM or FM
[MOD C or F]
Hovering Thr. [HV-T]
Idle Up [IDLE]
Throttle Hold [HOLD]
Model Select [MODL]
Trim Memory [TMEM]
Copy Model [COPY]
Parameters [PARA]
Failsafe [F/S]*
Hovering Pitch [HV-P]
Swash Type [SWSH]
Rudder Offset [R-OF]
Revolution Mix [REVO]
*Note: Failsafe menu
only appears in PCM
transmission mode.