___Press + to activate mix
___Arrow over
___Press + until first box says throttle
___Arrow over
___Press + until second box says ch 7
___Arrow over
___Pull throttle down and press + key until right # says 100%
___Push throttle up and then press + key until # says 100%
___Arrow over leave link OFF
___Arrow over and turn trim on (press + key)
___Arrow over leave offset 50%
___Arrow over to switch assignment
___Press + until says SW-C
___Arrow over
___Press + key until says CNTR/DWN
2. Left throttle operates properly on the throttle stick already with no changes
needed, so that is the up switch position for the channel 3 servo. However, the
channel 7 servo needs to be brought to idle, or kill, or however you want it set up.
We'll assume you want it to idle. To do so, offset mix channel 7:
Select a blank pmix, make it active, and select the first choice as OFS and second
as ch7. Make the percent 50% (you may need to adjust this to match your engine
and your desired result), link off, switch C up.
3. Now, we need to operate the channel 7 throttle but not the channel 3 throttle when
we move the throttle stick while in the down position. To do so, we do a pmix of
throttle to throttle, -100% each direction, link off, trim off, offset 50%, switch C
down. Now channel 7 operates, but channel 3 returns to neutral, not idle position.
Again, like we did in part 2, do an offset mix to solve this problem. Select an
available pmix, make it active, OFS to THR, 50% (adjust as needed), link off,
switch C down.
4. Lastly, we need to turn off the channel 7 knob to avoid its position affecting your
right engine, so pmix channel 7 to channel 7 -100% each direction, no link, 0
offset, no trim, and leave the switch setting as NULL.
DDD(65)&%&
(65)&%&(65)&%&
(65)&%&25&#%&6!6)5&
25&#%&6!6)5&25&#%&6!6)5&
25&#%&6!6)5&
565)!)2&)&++&6)+$2&%&4(
565)!)2&)&++&6)+$2&%&4(565)!)2&)&++&6)+$2&%&4(
565)!)2&)&++&6)+$2&%&4(
)H<--()/
"?9'
To Next Page
Loading...
