*8'*N
*
1. First of all, lets turn off the base controls for channel 7 so that we don't have a
problem with the slider normally assigned to this servo causing setting problems.
Set Au 1 to Null.
___From the home screen Press P for Model Menu
___Press B then K for Function
___Press K to select AU1 (channel 7)
___Press P for Control
___Press M for next twice
___Press E for Null.
B (N*L*
"*
/**@+
,)"/*
*/&4&%%4
K(FD)<
FFD#(.()@+0
/B",
3. Now, the first switch position is already ready! The left engine operates by itself
on the throttle stick. Let's get the second set up working now.
0F<
%+?,*"
___
Now, with switch C in the center (0) position, set up a pmix from channel 3
to channel 7.
___From home, press O for condition menu
___Press B then I for pmix
___Select a pmix which is not in use (for example, press F for pmix #1)
___press A then F to make it active
___Press B then G to make the master throttle
___Press C then K to make the slave channel 7 (Au 1)
To Next Page
Loading...
