___Press D then E to make it a linear mix
___
Press R then F to make the trims follow (so when you trim the one engine the
other engine responds as well)
___Press O for the next screen
___Leave the offset at 0%
___Press c then M to make the lower half of the throttle respond at 100%
___Press D then M to make the upper half of the throttle respond at 100%
+'
''/!..;!
.6F)*
K,
4. OK, time for the last switch position. Now, first, create a third condition, copying
condition SW C 0, and name it SW C 2 (or whatever you feel most comfortable
with) and assign it to Switch C position 2 ONLY.
D)B+,'9.DH
(/F<%*
#@
F"/**
"04
*5&%%4(FD)<FFD#(.()
'"'
'<(
/J/
""'J
K
))@FD)#*
I want to set up two servos to operate a single surface, but not use a preset feature
like flaperons or ailevators to do so. How can I do this with a mix?
To Next Page
Loading...
