/**5*
""'/
&%%4'(6--
/*//'BN761
A standard mix from 2 to 7 to work twin elevators:
___Choose a pmix not in use
___Press + to make it active (on/off)
___Press arrow over to get to the master channel
___Press + until it says ELEV
___Arrow over to slave channel
___Press + until it says CH 7
___Arrow over to the %
___Hold full down elevator and press the + key until it is +100
___Hold full up elevator and press the + key until it is +100
___Arrow over
___Leave link off
___Arrow over
___Press + to turn the trim follow on so your elevator trim will trim both servos
___Leave offset at 0
___Leave switch setting at NULL
I want to know about triple rates in conditions and over-riding one channel within a
condition for a higher rate.
)*1
/
)E!<1D8
0/*
Set ATVs. (In this example, ATV is 95%. The difference between ATV and AFR)
___From home, press key O for Condition
To Next Page
Loading...
