• I am setting up a twin engined-model and want to be able to command the engines
separately at certain times. Specifically, I always want the engines to respond only
to the throttle stick (never any knobs or other items), and I want the left engine to
operate alone if the C switch is in the up position with the right engine at idle; the
left and right engines operating together in the C center position, and the right
engine to operate alone in the C down position, with the left engine at idle. Can I
do this?
• I want to set up two servos to operate a single surface, but not use a preset feature
like flaperons or ailevators to do so. How can I do this with a mix?
• I want to know about triple rates in conditions and over-riding one channel within
a condition for a higher rate.
• I am setting up flaperons on my 9Z. The flaperon function works great for the
ailerons, but I can't seem to operate the flaps. What am I doing wrong?
• I want to use a module-based radio (for example, 7U, 8U or 9Z) on a different
frequency BAND than it currently uses. For example, I want to go to 75mHz for
ground use for battlebots, boats or cars, or I have a HAM license and want to use
the radio on 50mHz. Can I do this, and if so, how?
• When I set up varied conditions, my trims don't have the same amount of effect in
each condition. My 3D condition, for example, the trim has a much larger effect
than in my normal flight condition. How can I fix that?
• Can the 9Z's synthesized module and receiver be used with non-synthesized
modules and receivers?
• I own a 6X (or 8U or 9Z) airplane radio. I want to use it with helicopters. How do
I get it changed?
• I am looking for a 6+ channel computer radio on a ground frequency for use with
my boat, car, or other ground only vehicle. What is available to me?
• Can I use a receiver with a different number of channels than my transmitter (ex:
4ch Rx with 8ch Tx)? What about with the synthesized transmitter
module/synthesized receiver of the 9Z?
• How about setting up a complex 7-servo or 8-servo (8th servo being gasoline
engine kill switch) aerobat on the 9Z with 2-each flap and aileron servos?
• How can I get my gear doors to open and close delayed to the movement of my
gear?
• My ailerons work fine, but when I turn the flap knob they both move as ailerons.
What's wrong?
• Why are there different modules for the 9Z and the 8U? Can I use my 9Z module
in my 8?
• How can I move my throttle trim to the left slider on an aircraft model?
• What receivers can I use with my transmitter other than the model which shipped
with the radio?
• When I am using my radio for programming, setup within my house,
experimenting, etc, is there anything special I should do?
• I'm confused by some of the 9Z terms and abbreviations. Can you help?
• What are cross trims? Why does the trim beside the throttle adjust the elevator
and vice versa?
• I want to use flaperons with a 5-channel receiver. How can I do this?
To Next Page
Loading...
