• If I am using the DSC or if I have used the A or R key during turn-on to keep the
transmitter from transmitting, do I still need to extend one section of the antenna
or remove the module?
• Is there any risk to using cellular phones in close proximity with my radio?
• Please walk me through setting up the 9Z with the GV1.
• How do I completely reset my 9Z, clearing all memories, passwords, user name,
everything?
• I see a trim change on one channel when I go from high rate to low rate. I am not
changing conditions, just going to low rate. What's wrong?
• How do I know which glider type to select for my particular model?
• How do I properly range check my 9Z?
• Is there a synth module for 35mHz for use in the UK? Is it legal to use?
• How can I put expo or a curve into my throttle channel to give me linear throttle
reaction?
• When I go to the throttle cut screen in an aircraft model, the throttle position
option is not shown. Am I doing something wrong?
• How do I store the trims after a flight?
• Does the throttle cut feature in the aircraft programming have throttle position as
an option?
• When using the elevon feature of my computer radio, I give elevator input and the
surfaces move like ailerons. When I give aileron input they move like elevators.
What's wrong?
• I want to set up a safety on one of the auxiliary features on my model. For
example, I want my speed brakes to fully retract automatically if my throttle goes
above 1/3 throttle (I'd be making a go-around) to avoid the possibility of stalling
the plane. How can I do that?
• I want to create a mix which is only active if my throttle is above a certain point.
For example, I only want my smoke to come on if my throttle is above 1/2 to
avoid killing the engine. How can I do this?
• I want to trigger my high rates to only be active when I am above a certain engine
RPM on my heli. I can use stick position to trigger on the positive side, but on the
negative side it doesn't recognize that the engine is actually 'revved up'. How can I
make this work?
• If my receiver is PCM, do I need a PCM module or PCM crystal for my
transmitter? Do I need PCM crystals for it?
• How can I set up a 45-degree CCPM on a 9Z or 9Z WC2?
• How do I change this radio from FM to PCM or vice versa?
• Can the 9Z radios handle 140 degree CCPM? If so, how?
• What are the differences between a 9Z*P, W, and WC2 editions?
• How can I do differential rudder throw on a v-tail?
• How can I vary my onboard glow with throttle position?
• My model is CCPM but one of the functions is backwards. For example, my
elevator servo is forward on my swash plate, not aft, so the elevator function
works backwards. How do I fix that?
• How do I get aileron differential WITH flaperons?
To Next Page
Loading...
