___Press A then F to make active
___Press B and then F to select the elevator channel
___Press C and K to set 40% for the right elevator and D then K to set 40% for the left.
___
Press O and select the switch you wish to activate this dual rate. In this case, press A
then P to confirm that position. This makes this rate active only in the down position.
___Press N twice to End.
)@**''(
&27'
&27'&27'
&27')/
F) 0!E3!""*+)
,FE!
"*
&+7!)!5!'
&+7!)!5!'&+7!)!5!'
&+7!)!5!'220/
B%4) 1
___From Home press O for Condition menu
___Press B then I to open Pmix menu
___Press F to select mix 1 (or whichever key corresponds to your first open mix)
___Press A then F to make active
___Press B and then F to select the elevator channel
___Press C and then F to make elevator the slave channel as well
___DO NOT CHANGE Mix type, trim, or master mix mode
___Press O for the next screen
___Leave offset at 0
___
Press C to select "up" elevator, then E to reverse the mix, making it detracting
instead of additive
___Press I to set 80%
___Press D for the negative half of the elevator stick, then E to reverse the mix
___Press I to set 80% (full travel of 100% less the desired actual throw of 20%)
___Press N to exit the percent screen and P to enter the switch screen
To Next Page
Loading...
