6 = left ail
7 = left flap
8 = right flap
Select Flaperon From Home O D H
Activate Flaperon A F
NOTE: if aileron differential
is desired, set it up here
Operate two aileron servos
in unison as ailerons and as
flaps:
Set Flap Trim at 5% to
allow ability to adjust the
flaperon's trim and close
flaperon
R C F F F F F N N R
Go to Function Menu R B K
Select Channel 6 (AU1) and
assign Left Slider (LS)
O K P E
Operate the two flap servos
from the left slider
(remember to adjust your
geometry so slider all the
way up is 0 flap and slider
all the way down is 100%
downflap):
Select Channel 7 (AU2) and
assign Left Slider (LS) and
close the menu.
O L P E N R
Complete basic setup — servo direction, ATV, dual rates, exponential as desired.
Go to AirBrake Function: O D I
Make Active A G
Set Desired Distance (for
ex: 20% flap -5% ele)
C I D H GGGGG
Set up AirBrake to operate
the flaperons and elevator in
unison:
Assign to a switch ('C
down) and close the menu
P C P (if does not already
say "ON") N N R
Go to Pmix Function: O B I
Select mix 1 and make
active
F A F
Make it an offset mix: D F
Make Aux1 the slave: C K
Set the desired distance (ex:
20%)
O D I N
Mix each flap servo so it
moves in conjunction with
the AirBrake Function by
doing an offset mix (which
just moves the servo a set
distance) from the same
switch movement as
airbrake:
Assign the same switch ('C
down) and close the mix
P C P N N
To Next Page
Loading...
