Repeat for Aux 2 on mix 2
and close the menu
G A F D F C L O I N P C P
N N N R
Go to Elevator to Flap
Function and make it active:
O C K A F
Set desired travel (ex: 0%
down, 40% up)
C H D J
Use elevator-to-flaperon
mixing on switch C in the
up position:
Set to switch C Up and
close the menu
P C R (if does not already
say "ON") N N R
Go to Pmix 3 and make it
active:
O B I H A F
Set Master to Rudder and
Slave to Elevator
B H C F
Set the mix type to linear D E
Set the desired percent in
each direction (this you will
need to set based upon the
performance of your model.
Ex: +5% each way)
C H F F F F F D H F F F F
F N
Use a rudder-to-elevator
mix to mix out adverse pitch
couple when rudder is
applied:
Assign to switch H for
testing and close pmix menu
P H P (if not already set to
"ON") N N N R
Select Rudder-to Aileron
and make it active
O C I A F
Set desired percent in each
direction (this you will need
to set based upon the
performance of your model.
Ex: -5% each way)
C H G G G G G D H G G G
G G
Use the rudder-to-aileron
mix to mix out adverse roll
couple when rudder is
applied:
Assign to switch H for
testing and close pmix menu
P H P (if not already set to
ON") N N R
)@/"*J
F</*'
F<""*
To Next Page
Loading...
