Repeat for Aux 2, but
follows the channel 6 servo,
and set to -100% to operate
properly as aileron
Select Pmix 2, make it
active, linear, Flap master
linked, Aux 2 slave, 100%,
trim follow, master
unmixed, no switch
assignment, and close
menu.
O B I G A F D E B E M C L
R F Q G P I N O C M E D M
E N N N R
How can I get my gear doors to open and close delayed to the movement of my
gear?
)*'')
'''
''
'L''
'"
#*''/"R(
/&"
'+"C,%
E(B69*"
'"""'
B5"3
S
Set up everything as desired in the base condition except the gear up/down and gear door
operation.
Copy the base condition into 2 other
conditions, one called 'down' and
one 'up'.
See instructions on creating and copying
conditions.
With switch in 0 position, open
ATV and set gear channel delay
to 100%.
O B F R J M
Set the servo slow action in both
conditions.
Move switch to 2 position, set
door delay to 100%
O M M N R
To Next Page
Loading...
