With switch in 2 position, Select
and activate Pmix1
O B I F A F
In the gear up position, offset mix
gear 100%
Offset, switch null, 100%, gear
D F P I N C I O
M N N
In the gear up position, offset mix
aux2 100%
Select and activate Pmix 2
offset, switch null, 100%, close
the menu
O B I G A F D F
P I N C L O M
N N N R
My ailerons work fine, but when I turn the flap knob they both move as ailerons.
What's wrong?
)*"
1. Are the 2 servos plugged separately into the channels called for in your manual
(usually 1 and 6) or are they in a y-harness both into channel 1? If they are on a y-
harness, they cannot operate as flaps. Unplug the y-harness and plug the servos in
separately to the 2 channels.
2. The direction setup for one of the servos in the flaperon menu is incorrect. Go into
the flaperon programming and check that the flap percents set are opposite
directions of one another.
3. Other programming setup in the radio over-riding the flaperon commands. Try
using a blank model memory in the radio, get the one aileron servo operating
properly, activate flaperons, get the second servo operating properly as an aileron,
then try the flap knob.
Why are there different modules for the 9Z and the 8U? Can I use my 9Z module in
my 8?
))O'
)9))9
$6N676()"
)O
How can I move my throttle trim to the left slider on an aircraft model?
To Next Page
Loading...
