Set the Throttle at Desired
on Point, Set It, and Make
Mix Active Below That
Point.
(move throttle stick to
desired position)
Q* P
N N R
Open and Activate PMiX 2 O B I G A F
Select an Offset Mix D F
Select Smoke as Slave C L
Set the Offset to -100% O E M N
Assign to Throttle Stick P O C
*
2
2
0/
"2(2
*
3"
@@
)*'
*"
@@*'
E//
*@
@
Leave the Throttle at
Desired "On" Point, Set It,
and Make Mix Active
below That Point.
(move throttle stick to
desired position) Q* P
N N R
Go to Function (FNC)
Menu
P B K
Aux 2, Assign Switch F O L P M J
Now assign the function
(FNC) of Aux2 to switch G
so that when that switch is
off, smoke does not come
on, even with throttle.
Close the Menu N R
*Reverse the direction of the control if needed to make the mix activate correctly. In this
case, we want this mix active only when throttle is BELOW the set trigger point, so we
need "ACT" at the bottom of the screen and "INH" at the top.
J-@
/B/"?''/
')'''
'"?/""
'/
To Next Page
Loading...
