Open Pmix (PMX) 1 and
Make it Active
O B I F A F
Select a Linear Mix D E
Select Smoke as Slave C L
Set Throttle as Master B G
Assign to Smoke Switch
P G (confirm position is on
as desired) N
Set up a pmix (PMX) from
throttle to smoke which will
de-activate the smoke servo
if the throttle is below about
1/4 throttle. (This is actually
a progressive linear mix but
as the electronic switch is
only on/off, this is
acceptable.)
Set offset and mix % to -
100
Move throttle stick to top
B F C M E D
M E N N R
Go to Function (FNC)
Menu
P B K
Aux 2, Assign Switch F O L P M J
Now assign the function
(FNC) of Aux2 to switch G
so that when that switch is
off, smoke does not come
on, even with throttle.
Close the Menu N R
I want to trigger my high rates to only be active when I am above a certain engine
RPM on my heli. I can use stick position to trigger on the positive side, but on the
negative side it doesn't recognize that the engine is actually 'revved up'. How can I
make this work?
)"*
")"
"/*"
)"*"
")
"U6D)/'
@
If my receiver is PCM, do I need a PCM module or PCM crystal for my
transmitter? Do I need PCM crystals for it?
To Next Page
Loading...
